Table of Contents
Advertisement
When an Additional IDE
Drive is Installed
When the Bootable IDE
Drive is Replaced
NOTE
3 How to Install Accessories Inside Your PC
Installing Mass Storage Devices
Completing the Installation of an IDE Drive
After installing an IDE drive you will need to run the SETUP program
to confirm that the drive has been detected by the PC.
1 Switch on the PC.
2 When
<Setup=F2>
3 In the
Hard Disk Drives
have been correctly detected by the SETUP program.
Drive 2
4 Press
to save and exit SETUP.
Refer to the operating system documentation for information on
formatting a drive and installing the operating system.
1 Switch on the PC.
2 An error message will appear during the Power-On-Self-Test. When
prompted, press
3 In the
Hard Disk Drives
have been correctly detected by the SETUP program.
Drive 1
4 Press
to save and exit SETUP.
Refer to the operating system documentation for information on
formatting a drive and installing the operating system.
If an IDE drive is removed, an error message will appear during the
Power-On-Self-Test. You must run the SETUP program and select
for the missing drive to correct the error.
None or SCSI
52
English
appears, press
section, check that the details for
to run the SETUP program.
section, check that the details for
to run the SETUP program.
Advertisement
Table of Contents
