Completing The Installation Of A Hard Disk Drive; Installing A Drive In A Front-Access Shelf - HP Kayak XW U3-W3 Installation Manual

When a SCSI Hard
Disk Drive Is Installed
When an IDE Drive
Is Installed
NOTE
HP Kayak XW U3 & W3 PC Workstation — Installing Accessories In Your HP PC Workstation

Completing the Installation of a Hard Disk Drive

1 Switch on the computer.
2 To ensure compatibility, use the FDISK utility to delete any
partitions on the new hard disk.
3 Re-boot the computer.
Refer to the operating system documentation for information on
formatting a drive.
1 Switch on the computer.
2 To display the device in POST, press
re-starts.
3 If an error message appears, follow the instructions provided by the
Error Message Utility. When prompted, press
program.
4 Select the Advanced menu, and the IDE Devices submenu. In the
Primary Master item, check that the details for the device have been
correctly detected by the Setup program.
5 Press to save and exit Setup.
Refer to the operating system documentation for information on
formatting a drive.
If an IDE drive is removed, switch on the computer. The system BIOS
will detect that the device is missing. Press
to remove the device. The system configuration will be updated
automatically.

Installing a Drive in a Front-Access Shelf

These instructions explain how to install a drive (such as a flexible
disk drive, a CD-ROM drive, CD-RW drive, or a tape drive) in one of
the front-access drive shelves. You should also refer to the manual
supplied with the drive for any additional installation instructions.
Installing Mass Storage Devices
while the PC Workstation
to run the Setup
to confirm that you want
English
19