Replacing The Power Supply Unit - HP Kayak XA User Manual

mamdt.bk : mamdt2.fb4 Page 30 Tuesday, August 5, 1997 4:20 PM
2 Installing Accessories in Your PC Workstation
Moving and Replacing the Power Supply Unit

Replacing the Power Supply Unit

1 Before replacing the power supply unit, ensure that the hard disk
drive(s), and the LAN or LAN/SCSI board (some models only), are
correctly installed and that all data and power cables are properly
connected and correctly routed.
2 Lift the front of the power supply unit (the fan end) and slide it into
the rear of the PC Workstation. Ensure that the hinge on the back of
the power supply engages the notch on the chassis. Then lower the
front of the power supply unit so that the catch on either side slides
into place.
3 Always replace the PC Workstation's cover before connecting the
power cord (refer to page 28).
30 English