HP Kayak XA User Manual page 70

mamdt.bk : mamdt3.fb4 Page 60 Tuesday, August 5, 1997 4:20 PM
3 Troubleshooting Your PC Workstation
If Your PC Workstation Does Not Start Properly
Clearing the PC Workstation's Configuration Memory
If the PC Workstation then starts, but POST still persists in reporting
an error, clear the current configuration memory values and reinstall
the built-in default values:
1 Turn off the PC Workstation, disconnect the power cord and all
cables, and remove the cover.
a Set the system board switch 6 (CMOS STATUS) to CLOSED to
clear the configuration.
b Replace the cover, and reconnect the power cord only.
c Turn on the PC Workstation. This erases the CMOS memory.
d Wait until the PC Workstation has started. A message is displayed
similar to this:
"Configuration has been cleared, set switch 'Clear CMOS'
to the OPEN position before rebooting."
Turn off the PC Workstation, disconnect the power cord, and
remove the cover.
e Set the system board switch 6 (CMOS STATUS) on the switch
block to OPEN to re-enable the configuration.
2 Replace the cover, and reconnect the power cord and all cables.
3 Turn on the PC Workstation. An error message similar to the one
shown below is displayed:
"Incorrect PC configuration"
The PC Workstation stops. Press any key to continue.
4 Run the Setup program by pressing
automatically downloaded and saved.
5 Make any other changes you want and press
configuration and exit from the Setup program.
60 English
. CMOS default values are
to save the