Removing An Accessory Board - HP Kayak XA User Manual

mamdt.bk : mamdt2.fb4 Page 52 Tuesday, August 5, 1997 4:20 PM
2 Installing Accessories in Your PC Workstation
Installing Accessory Boards
11 Depending on which operating system you have, and whether you
have installed a Plug and Play or a non-Plug and Play board, your
system may be able to automatically configure the new board. Refer
to your operating system documentation for more information.
12 If you experience any problems as a result of the upgrade, refer to
Chapter 3, starting on page 55.

Removing an Accessory Board

You might need to remove an accessory board to improve access to
components on the system board.
1 Turn off the display and computer, and disconnect the power supply
cords and any connection to a telecommunications network.
2 Remove the computer's cover (refer to page 27).
3 Unscrew and remove the retaining bracket. Put the screw to one
side.
4 Carefully remove the board from its connector, holding the board at
each end by its top edge. Do not bend the board. If you intend to
replace the board later, note which connector it is in.
5 With its components facing up, place the board on a clean, flat, solid,
static-free surface. Handle the board by its edges.
6 Install any new accessories.
7 Replace the accessory board if necessary (refer to page 50).
8 Replace the retaining bracket.
9 Replace the cover and then reconnect all cables and power cords.
52 English