Installing The Dust Bag; Installing Extension Wings - Erbauer ERB2502SE User Manual

4. Installing the dust bag

1) Squeeze the metal collar wings (2) of the dust
bag (1).
2) Place the dust bag neck opening around the
exhaust port (3), and release the metal collar
wings. (See fig. 6).

5. Installing extension wings

To avoid injury or possible damage to the tool,
support long workpieces by installing the extension
wings to extend the work support surface.
The extension wings are provided with a stop
block. The extension may be used with or without
this piece.
To install the stop block:
1) Slide the stop block (1) onto the rail (2) of the
right extension wing.
2) Thread the wing bolt (3) into the bracket and
tighten.
3) Place the extension wings into the holes
provided in the mitre saw base.
4) Insert a Phillips screws (4) into hole and
tighten to hold the extension wings. (See fig. 7).
6. Installing the hold-down clamp
assembly
1) Loosen the lock knob (3) from the rear side of
the saw base (4) .
2) Place the hold-down clamp assembly (1) in one
of the mounting holes (2).
3) Tighten the lock knob (3). (See fig. 8)
13
254MM (10") COMPOUND MITRE SAW 254MM (10") COMPOUND MITRE SAW
1
2
3
Fig 6
3
Fig 7
1
3
4
Fig 8
4
1
2
2
13