External Remote Control; Remote Operation Of External Devices - Panasonic AJ-HPD2500P Operating Instructions Manual

Remote Operation of External Devices

Use the RS-422A interface to send commands to an external
device to control it.
The following functions permit remote control.
• PLAY, STOP, SEARCH, FF, REW
• Counter and status LED indication
Setup Procedure
1
1
Press the PLAYER button.
This allows the unit to perform remote control of external
devices.
◆ NOTE:
• When performing remote control of external devices, set setup
menu No.25 (SYSTEM FREQ) to 59.94, 50, 23.98, 24, 29.97 or 25.
• Complete any settings required for controlling a remotely connected
device before switching.

External Remote Control

Indications during control of external
devices
In external control mode, the PLAYER lamp goes on and the
unit provides the following indications.
• The LED goes on to indicate external device status.
• Indicates the external device counter
• The unit is forcibly set to EE to enable reception of audio
and video from the external device
• Counter, status and P mark indications for the external
device are superimposed on the screen.
Remote operation procedure
The control buttons listed below enable remote control of an
external device.
STOP Sends the STOP command.
PLAY Sends the PLAY command.
SEARCH Sends the JOG, VAR or SHTL command.
REW Sends the REW command.
FF Sends the FF command.
Dial Sends the JOG, VAR or SHTL command.
COUNTER Sends the switch COUNTER command
(CTL/TC only).
RESET Sends the 0 reset command in CTL mode.
Connections: External Remote Control
137