Removing The Rear Panel - Electrolux Built-in Ovens Service Manual

3.5. REMOVING THE REAR PANEL (various components and lamp socket)
To remove the rear panel, simply remove the two upper screws.
This gives access to the following components: lamp socket, convection motor, spit motor,
terminal block + wire clamp, grill heating element (if featured), spark generator and the oven
burner coupling.
Fig. 54
1. GRILL HEATING ELEMENT
2. OVERHEATING THERMOSTAT
(TANGENTIAL FAN CONTROL)
3. CONVECTION FAN
4. GAS PIPE TO BURNER
SOI 04.04 FV
ELECTROMECHANICAL VERSION
5. EARTH CONNECTION
6. LAMP SOCKET
7. SPARK GENERATOR
8. TERMINAL BLOCK
9. WIRE CLAMP
10. POWER CABLE
30/50 599 35 96-40