Electrolux Built-in Ovens Service Manual page 49

6. Use a small screwdriver to adjust the thermostat by-pass pin (fig. 93, pos. C). If converting
from methane to LPG, turn the by-pass pin fully clockwise. To convert from methane to
town gas, turn the screw 1/2 turn counter-clockwise.
Fig. 93
C. BY-PASS PIN FOR
ADJUSTMENT OF
MINIMUM SETTING
7. Replace all the components, repeating the above operations in reverse sequence.
8. Re-connect the appliance to the power supply.
NEVER RE-CONNECT TO THE POWER SUPPLY BEFORE REPLACING ALL THE
COMPONENTS
9. Switch on the oven burner, adjust the thermostat to the maximum setting, and wait for at
least 10 minutes.
10. Turn the thermostat knob rapidly from the maximum setting to the minimum setting and
check that the burner does not switch off.
11. If the burner switches off, repeat the entire procedure (step 1 to step 10) until the flame is
small and burns evenly.
SOI 04.04 FV 49/50 599 35 96-40