Electrolux Built-in Ovens Service Manual page 26

3. Remove the front panel
Proceed as follows to replace the front panel:
1. Position the upper edge of the panel first.
2. Move the lower edge into position
3. First fit the screws which secure the panel to the external casing, then the screws which
secure the panel to the muffle (oven compartment).
IMPORTANT: Before inserting the screws, adjust the position of the front panel so that it is in
alignment with the holes. If necessary, raise the muffle slightly.
If difficulties are encountered when replacing the front panel, proceed as follows:
1. Remove the lateral uprights.
2. Insert the front panel as described above.
3. Fit the internal screws which secure the front panel to the casing.
4. Replace the lateral uprights.
N.B.: Access to the front panel in the manner described above refers to appliances with
serial numbers starting from 336........
In the case of preceding models (a few hundred appliances only), some holes in the
oven casing are not pre-drilled, which makes access more difficult. In order to access
the screws that secure the front panel in position, it is necessary to move the muffle
rearwards (loosen or remove the screws).
SOI 04.04 FV
Fig. 45
26/50 599 35 96-40