Panasonic S-45PU1E5 Technical Data & Service Manual page 196

1
HOW TO INSTALL THE INDOOR UNIT
Ceiling Type (T1 Type)
Required Minimum Space for Installation and Service
(1) Dimensions of suspension bolt pitch and unit
Length
Type
36, 45, 50
60, 71
100, 125, 140
(2) Refrigerant tubing • drain hose position
Left side
2 5 1
Closed with rubber stopper at time of shipment.
(3) Unit opening position (Refrigerant tubing • drain hose • power inlet port • remote controller wiring inlet port)
Left-side drain hose
outlet port
*3
Remote controller
wiring inlet port
(ø30, knock-out)
*1
Side panel
*3
Remote controller wiring
inlet port
(ø30, rubber grommet on
right side only)
A B
855 910
1125 1180
1540 1595
Rear (Figure shows view from front)
8 4
Left drain position
123
Knock-out
Outside air intake duct connection port
(ø100, knock-out)
Power inlet port
(ø40, knock-out)
Rear tubing hole
Left-side drain
84
hose outlet port
C
210
27.5
210
210
Unit: mm
7 5
Liquid
tubing
Gas tubing
1 4
Right drain position
Top outlet port
216
110
Power inlet port
(ø40, knock-out)
*2
Rear outlet port
262
125 72
347
Unit: mm
1-190
B
Ceiling side
27.5
A
(Suspension bolt pitch)
Unit: mm
Right side
9 7
6
Right-side drain
76
hose outlet port
Position of plate
Side panel
inside side panel
*1 Use a compass saw, jig saw or similar tool
and cut along the indented portion of the side
panel.
*2 If the optional drain up kit is installed, this
becomes the upper tubing outlet port.
For details, refer to the manual for the
optional part.
*3 If the remote controller wiring inlet port is
changed to the left side or the left top side,
relocate the rubber grommet to the left side.
Use aluminum tape or similar material to seal
the unused inlet port on the right side.
C
Air intake
Air
Fig. 3-1
2 1 6
(Liquid tubing •
Gas tubing)
1 6 1
251
Unit: mm
Fig. 3-2
*1
Fig. 3-3