Booting - AddPac VoiceFinder AP1200 Installation Manual

VoiceFinder AP1200 VoIP Gateway Installation Guide Version 1.0

Booting

When power is supplied, the system is booted as described below
VoiceFinder AP1200 Gateway performs a self-test and checks basic operations of
the CPU, the memory and interfaces.
The boot loader is executed, and the boot loader seeks for proper software image
files. The boot loader loads the gateway software from the flash memory.
If the boot loader cannot find proper software image file from the flash memory, the
boot loader stands by in the boot mode until it receives proper software from the
remote system.
TFTP or FTP protocol.)
When the software is loaded, the gateway starts to operate according to
configuration information.
operates according to the default values, and in this case, the operator shall set up
necessary parameters for normal operation of the network.
After connecting all the interfaces, supply power to VoiceFinder AP1200 Gateway.
Danger
Supply the power after connecting the adapter to VoiceFinder AP1200 Gateway. Do not
connect the adapter to the power supply before connecting it to the gateway.
use 110V adapter in case the power supply is 110V.
both 110V and 220V, so there is no additional setting required.
AddPac Technology Co., Ltd.
(At this time, the boot loader can download software through
However, if there is no configuration information, it
However, the gateway detects
-
Also,
33
-