Port Cover; Power Supply, External - HP EliteDesk 800 G1 Tower Service Manual

Port cover

Description
Port cover
An optional rear port cover is available for the computer.
To install the port cover:
1.
Thread the cables through the bottom hole on the port cover (1) and connect the cables to the rear
ports on the computer.
2. Insert the hooks on the port cover into the slots on the rear of the chassis, then slide the cover to
the right to secure it in place (2).
NOTE: For security purposes, you can install an optional cable lock to the chassis that locks the port
cover and secures the computer.
The port cover is secured in place by a retention lever just inside the port cover opening. To remove the
port cover, pull the lever back towards the port cover opening (1), then slide the cover to the left and
off the computer (2).

Power supply, external

The USDT chassis uses an external power supply.
WARNING!
replacement power supply provided by HP, or a power supply purchased as an accessory from HP
should be used with the computer.
To reduce potential safety issues, only the power supply provided with the computer, a
Spare part number
588981-001
Port cover
179