Wlan Module - HP EliteDesk 800 G1 Tower Service Manual

WLAN module

Description
HP WLAN 802.11 a/b/g/n 2x2 PCIe NIC
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
Remove the optical drive
4.
Remove the hard drive
5.
Remove the drive cage
6. Disconnect the two antenna cables from the connectors on the module (1).
7. Remove the two Phillips screws (2) that secure the module to the system board.
8.
Lift the module to a 45 degree angle, and then remove the module from the connector by pulling it
away at an angle (3).
To install the WLAN module, reverse the removal procedure. Make sure the antenna cables are
correctly routed.
168 Chapter 7 Removal and replacement procedures: Ultra-slim Desktop (USDT)
(Preparation for disassembly on page
(Access panel on page
(Removing the optical drive on page
(Hard drive on page 154).
(Drive cage on page 164).
142).
151).
Spare part number
695915-001
141).