Speaker - HP EliteDesk 800 G1 Tower Service Manual

Speaker

Description
Speaker
The speaker is attached to the front of the chassis under the rotating drive cage.
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
Remove the front bezel
4.
Rotate the drive cage to its upright position.
5.
Disconnect the speaker wire from the white system board connector labeled SPKR.
6.
Remove the two Torx screws that secure the speaker to the chassis.
7.
Lift the speaker from the inside of the chassis to remove it.
To install the speaker, reverse the removal procedures.
134 Chapter 6 Removal and replacement procedures: Small Form Factor (SFF)
(Preparation for disassembly on page
(Access panel on page
(Front bezel on page 96).
95).
Spare part number
727149-001
94).