Installing A 3.5-Inch Device - HP EliteDesk 800 G1 Tower Service Manual

Installing a 3.5-inch device

1. Prepare the computer for disassembly
2. Remove the access panel
3. Remove the front bezel
a bezel blank, remove the bezel blank. See
4. Install 6-32 guide screws in the holes on each side of the drive.
NOTE:
on page 108
When replacing a drive, transfer the four 6-32 guide screws from the old drive to the new one.
5. Rotate the drive cage to its upright position.
6. Slide the drive into the drive bay, making sure to align the guide screws with the guide slots, until
the drive snaps into place.
112 Chapter 6 Removal and replacement procedures: Small Form Factor (SFF)
(Access panel on page
(Front bezel on page
HP has supplied four extra 6-32 guide screws on top of the drive cage. Refer to
for an illustration of the extra guide screws location.
(Preparation for disassembly on page
95).
96). If you are installing a drive in a bay covered by
Bezel blanks on page 99
94).
for more information.
Drives