Hood Sensor - HP EliteDesk 800 G1 Tower Service Manual

Hood sensor

Description
Hood sensor
1.
Prepare the computer for disassembly
2.
Remove the access panel
3. Disconnect the cable from the system board connector labeled HSENSE (1).
4. Using a tool, remove the sensor from the slot by pushing it into the computer to remove it (2).
To install the hood sensor, reverse the removal procedure.
128 Chapter 6 Removal and replacement procedures: Small Form Factor (SFF)
(Preparation for disassembly on page
(Access panel on page 95).
Spare part number
638816-001
94).