HP EliteDesk 800 G1 Tower Service Manual page 187

6.
Remove the drive cage
7.
Remove the heat sink
8.
Remove the system board
9.
Remove the rear fan
10.
To remove the front antenna, from the inside of the front of the chassis, remove the antenna from
the clips built into the base pan.
11. From the outside of the front of the chassis, remove the two Torx T8 screws (1) that secure the
antenna to the chassis.
(Drive cage on page
(Heat sink on page 157).
(System board on page
(Rear fan on page 173).
164).
171).
Antennas
175