HP EliteDesk 800 G1 Tower Service Manual page 72

Hide thumbs Also See for EliteDesk 800 G1 Tower:
Table of Contents

Advertisement

2.5-inch hard drive bay, the second connector routed to the middle 3.5-inch hard drive bay, and
the third connector routed to the top 3.5-inch hard drive bay.
You must install guide screws to ensure the drive will line up correctly in the drive cage and lock in
place. HP has provided extra guide screws (four 6-32 silver and blue isolation mounting guide
screws and four silver 6-32 standard guide screws) installed on the side of the drive bays. The
6-32 isolation mounting screws are required for 3.5-inch hard drives installed in the 3.5-inch hard
drive bays. The 6-32 standard guide screws are required for a USB 3.0 media card reader
installed in the 3.5-inch optional drive bay. M3 metric guide screws for 5.25-inch optical drives
and M3 isolation mounting guide screws for 2.5-inch hard drives are not provided. If you are
replacing a drive, remove the guide screws from the old drive and install them in the new drive.
No.
Guide Screw
1
Silver Standard 6-32 Guide Screws
2
Silver and Blue 6-32 Isolation Mounting Screws
60
Chapter 5 Removal and replacement procedures: Tower (TWR)
Device
USB 3.0 Media Card Reader
Secondary Hard Drive in 3.5-inch Hard Drive Bay

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents