Wlan Module - HP ProDesk 405 G4 Small Form Factor Maintenance And Service Manual

WLAN module

The WLAN module installs into a connector on the system board.
For a list of available WLAN modules, see the
To remove the WLAN module:
1. Prepare the computer for disassembly
2. Remove the access panel
3. Remove the drive cage
4. Disconnect the WLAN antenna cables (1) from the terminals on the WLAN module.
NOTE:
WLAN antenna cable labeled 2 connects to the WLAN module Aux terminal labeled 2.
5. Remove the Phillips screw (2) that secures the WLAN module to the computer. (The edge of the module
opposite the slot rises away from the computer.)
6. Remove the WLAN module (3) by pulling the module away from the slot at an angle.
NOTE:
Reverse this procedure to install the WLAN module.
(Access panel on page
(Drive cage on page
The WLAN antenna cable labeled 1 connects to the WLAN module Main terminal labeled 1. The
WLAN modules are designed with a notch to prevent incorrect insertion.
Computer major components on page
(Preparation for disassembly on page
18).
22).
4.
17).
WLAN module 43