Table of Contents
Advertisement
WLAN module
The WLAN module is located near the top of the system board. The WLAN module is secured with one Phillips
screw and has two connected antennas.
For a list of available WLAN modules, see
NOTE:
The procedure to replace the WLAN module must be performed by an HP technician.
To remove the WLAN module:
1.
Prepare the computer for disassembly (see
2.
Remove the stand (see
3.
Remove the rear port cover (see
4.
Disconnect the antenna cables from the module (1).
5.
Remove the Phillips screw (2) that secures the module to the computer.
6.
Lift the module to a 45-degree angle, and then pull it away to remove it from the socket (3).
To install the WLAN module, reverse the removal procedures.
When connecting the antennas cables, connect the cable labeled "1" (black sticker) to the AUX "1" connector
on the module and the cable labeled "2" (white sticker) to the MAIN "2" connector on the module.
NOTE:
WLAN modules are designed with a notch to prevent incorrect insertion.
32
Chapter 4 Removal and Replacement Procedures
Illustrated parts catalog on page
Preparing to disassemble the computer on page
Stand on page
21).
Rear port cover on page
8.
23).
21).
Advertisement
Table of Contents
