Installing a 3.5-inch device
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
Remove the front bezel
drive in a bay covered by a bezel blank, remove the bezel blank.
4.
Slide the device into the drive bay (1) and install the two 6-32 mounting screws in the side of the
device (2) to secure it in place.
NOTE:
When replacing a device, use the two 6-32 mounting screws that were removed from the old
device to install the new one.
46
Chapter 5 Removal and replacement procedures: Microtower
(Access panel on page
(Front bezel on page
HP has supplied extra 6-32 mounting screws on the front of the chassis behind the bezel.
(Preparation for disassembly on page
27).
28). Remove the front bezel. If you are installing a
26).