Installing A 3.5-Inch Device - HP EliteDesk 705 G1 Desktop Mini Maintenance And Service Manual

6. Press inward on the release lever at the rear of the drive (1) and slide the drive out of the rear of the
drive bay (2).

Installing a 3.5-inch device

1. Prepare the computer for disassembly
2. Remove the access panel
3. Remove the front bezel
blank, remove the bezel blank. See
4. Install 6-32 guide screws in the holes on each side of the drive.
NOTE:
Removing Drives on page 86
When replacing a drive, transfer the four 6-32 guide screws from the old drive to the new one.
5. Rotate the drive cage to its upright position.
(Access panel on page
(Front bezel on page
HP has supplied four extra 6-32 guide screws on top of the drive cage. Refer to
for an illustration of the location of the extra guide screws.
(Preparation for disassembly on page
73).
73). If you are installing a drive in a bay covered by a bezel
Bezel blanks on page 75
72).
for more information.
Installing and
Drives 89