Assembly Instructions - Tera Gear TG 1201 2561 Instruction Manual

Remove all contents from the carton packaging. Make sure all parts are present before attempting assembly. Once the
grill is fully assembled, go back and check to make certain all the bolts are secure. Tighten again using the screwdriver
provided if necessary.
Estimated assembly time: 30 minutes.
Magnet
Step 1 (The assembly)
Note: Before beginning assembly, make certain the two
swivel casters on the cart bottom (A) are locked.
a) Align the holes on the magnets (B) with the holes on
the cart bottom (A). Insert one bolt (AA), one spring
washer (DD) and one flat washer (CC) into each
pre-drilled hole. Tighten bolts by hand until secured.
b) Go back and tighten all bolts using the screwdriver
provided.
Step 3 (The cart back panel assembly)
a) Align the four holes on the cart back panel (E)
with the four holes on the cart right side panel
and cart left side panel.
b) Insert one bolt (AA) and one flat washer (CC) into
each hole and then tighten all bolts using the
screwdriver provided.
GSS3220AN
Instruction Manual

Assembly Instructions

Step 2 (The cart side panels assembly)
a) Loosen the six pre-installed bolts on the cart bottom (A) and
allow 1/4 bolt's length to extend from the bottom assembly.
b) Align the three large holes on the cart left side panel (C)
with the three bolts extended from the bottom assembly.
c) Slide the cart left side panel (C) until it locks into place.
Tighten bolts by hand until secured.
d) Repeat the procedure for the cart right side panel (D)
assembly.
e) Go back and tighten all bolts using the screwdriver
provided.
7