Natural gas stainless steel split lid gas grill (20 pages)
Summary of Contents for Tera Gear TG 1201 2561
Page 1
TG 1201 2561 NG 720958 Natural gas barbecue WARNING: Improper installation, adjustment, alteration, service or maintenance can cause injury or property damage. Read the installation, operation and maintenance instructions thoroughly before installing or servicing this equipment. DANGER: Failure to follow these...
Grill Operation 1-2-3 Before Grilling Step 1 Keep your grill a safe distance away from your property. Step 2 Always perform a leak test on all connections and hoses. Step 3 Keep children away from the grill. During Grilling (To avoid tripping safety valves, please follow these instructions carefully!) Step 1 First open lid and turn gas tank on slowly.
Table of Contents For Your Safety ........................ 2 Package Contents ......................5 Hardware Contents ......................6 Assembly Instructions..................... 7 Operating Your Grill....................... 13 Natural gas connection....................14 Checking for Leaks......................14 Lighting Your Grill......................15 Excess flow safety valve reset procedure ..............17 Care and Maintenance ....................
Page 4
WARNING: This grill is for outside use only. It should not be used in a building, garage or any other enclosed area. The use of alcohol, prescription or non-prescription drugs may impair an individual’s ability to properly assemble or safely operate this appliance. Always open the grill lid carefully and slowly as heat and steam trapped within the grill could cause severe burns.
might otherwise be sufficient to ignite nearby combustible or volatile substances. Always locate this grill where there will be ample combustion and ventilation air, but never position it in the direct path of a strong wind. Never allow the grill to operate while unattended to prevent uncontrolled grease fires from erupting.
Package Contents Part Description Part Description Right side shelf Cart bottom 1 PC 1 PC Door magnet Side knob 1 PC 1 PC Cart left side panel 1 PC Knob seat 1 PC Cart right side panel 1 PC Side burner frame 1 PC Cart back panel 1 PC...
Assembly Instructions Remove all contents from the carton packaging. Make sure all parts are present before attempting assembly. Once the grill is fully assembled, go back and check to make certain all the bolts are secure. Tighten again using the screwdriver provided if necessary.
Page 9
Step 4 (Assemble the front beam to the cart) a) Place the front beam (F) on the two cart side panels. b) Align the two holes on the right end of front beam (F) with the top & side two holes on the frame of cart right side panel.
Page 10
Step 7 (Door assembly) Insert the bottom pin of left door (I-1) into the pre-drilled hole on the cart bottom panel. Push down the top pin of left door and insert it into the pre-drilled hole on the left end of cart front beam.
Page 11
Step 10 (Side knob & knob seat assembly) Align the holes on the side knob seat (N) with the holes on the right side shelf and the side burner valve. Screw one bolt (BB) and one flat washer (EE) into each pre-drilled hole by hand. b) Tighten the bolts using the screwdriver provided.
Page 12
Step 12 (Wire assembly) Insert the transformer wire through the slots on the side panel and then insert the two ends of the light wire from above with the two ends of the transformer wire. Step 13 (Heat plate, cooking grid and warming rack assembly) a) Place the heat plates (P) onto the heat plate support.
Page 13
Step 15 (Grease cup assembly) a) Put the grease cup (T) into the grease cup support (S). Hang the cup support on the grease pan. b) Pull in the grease pan by moving it through the guide track under the body assembly.
Fully Assembled View Left Side Right Side Operating Your Grill CAUTION: Use only the regulator provided. If a replacement is necessary, call our customer service center. The use of unauthorized parts can create an unsafe condition and environment. Your natural gas grill has been designed to operate on natural gas only, at a pressure of seven inches water column (7” W.C.).
Natural Gas Connection During high pressure testing your gas grill and its individual shutoff valve must be disconnected from the gas supply piping system. During any pressure testing of that system at least pressures in excess of 1/2 psi (3.5kPa). During low pressure testing your gas grill must be isolated from the gas supply piping system by closing its individual manual shutoff valve during any pressure testing of the gas supply piping system at test pressures equal to or less than 1/2 psi (3.5kPa).
Lighting Your Grill DANGER: Failure to open lid while igniting the grill’s burners or not waiting five minutes to allow gas to clear if the grill does not light, may result in an explosion, which could cause serious bodily injury or death. WARNING: Never stand with your head directly over the grill when preparing to light the main burners, to prevent possible bodily injury.
Page 17
Remove the lighting stick then insert a match into the end of lighting stick. Light the match. Once lit, place the flame to reach the burner ports. (See diagram to right.) Press the control knob and rotate it counterclockwise to the ‘’HIGH’’ position.
Flare-ups “Flare-ups” sometimes occur when food drippings fall onto the hot heat distribution plate or burners and ignite. Some flaring is normal and desirable as it helps impart the unique flavors associated with grilled foods. Controlling the intensity of the flare-ups is necessary, however, in order to avoid burned or unevenly cooked foods and to prevent the possibility of accidental fire.
Page 19
Mild dishwashing liquid detergent Hot water Nylon cleaning pad Wire brush Paper clip Putty knife/scraper Compressed air DO NOT use cleaners that contain acid, mineral spirits or xylene. Outside surfaces Use a mild dishwashing detergent and hot water solution to clean. Rinse thoroughly with water. Inside surface If the inside surface of the grill lid has the appearance of peeling paint, baked on grease has turned to carbon and is flaking off.
Troubleshooting Problem Possible Cause Prevention/Cure urner will not light using knobs or Wires and/or electrode covered with Clean wire and /or electrode with igniter. cooking residue. rubbing alcohol. Electrode and burners are wet. Wipe dry with cloth. Electrode cracked or broken – Replace electrode.
Grease buildup. Clean grill. Flare-up. Excessive fat in meat. Trim fat from meat before grilling Excessive cooking temperature. Adjust (lower) temperature accordingly. Grease trapped by food buildup Turn knobs to OFF. Turn gas OFF at Persistent grease fire. around burner system. propane tank.