Lighting Your Grill - Tera Gear TG 1201 2561 Instruction Manual

DANGER:
Failure to open lid while igniting the grill's burners or not waiting five minutes to allow gas to clear if the grill does not
light, may result in an explosion, which could cause serious bodily injury or death.
WARNING:
Never stand with your head directly over the grill when preparing to light the main burners, to prevent possible bodily
injury.
Lighting Main Burner
1. Open lid while lighting burners.
WARNING:
an explosion. Make` sure there are no obstructions of airflow to the gas unit. Spiders
and insects can nest and clog the burner/venturi tube at the orifice. A clogged burner
tube can lead to a fire beneath the appliance.
2. All valves must be in the "OFF" position.
3. Open natural gas valve.
4. To ignite, push and turn desired knob slowly about 1/4 turn counter clockwise until a click is heard.
(See diagram to right.)
5. The "click" is the ignitor being activated. If the burner does not light,
repeat 2 or 3 times.
6. If ignition does NOT occur in 5 second turn the burner controls to OFF, wait 5
minutes, and repeat the lighting procedure.
7. To ignite remaining burners, repeat same procedure for adjacent burner and continue in sequence.
8. Adjust valve knob(s) to desired cooking temperature.
Using the Lighting Stick to Light the Main Burners
1. Insert a match into the end of lighting stick locked in the drawer. Light the match.
2. Once lit, put the lighting stick through the cooking grid and place the flame next to
the burner ports found along the sides of the desired burner (See diagram to right.)
3. Press the valve knob and rotate it counterclockwise to the ''HIGH''
position. The burner should light immediately. If more than one burner
is desired, repeat the procedure 2-3 until all desired burners are lit.
4. Adjust burners to the desired cooking temperature.
Precautions:
1. After lighting, observe the burner flame. Make sure all burner ports are lit.
2. If the burner flame goes out during operation, immediately turn the gas "OFF". Open lid to let the gas clear for at
least 5 minutes before re-lighting.
3. Before cooking on the grill for the first time and operate the grill for approximately 15 minutes with the lid closed and
the gas turned on "HIGH". This will "heat clean" the internal parts, dissipate odor from the manufacturing process
and painted finish.
4. Clean the grill after each use. DO NOT use abrasive or flammable cleaners. This may damage parts of the grill and
cause a fire.
Lighting Side Burner
1. Open lid while lighting the burner. Lid must remain open while burner is lit.
2. Valve must be in the "OFF" position.
3. Open natural gas valve.
Push the side burner valve knob and rotate slowly about 1/4 counterclockwise
until a click is heard. The burner should be lit.
If ignition does NOT occur in 5 seconds turn the burner controls to OFF,
wait 5 minutes, and repeat the lighting procedure.
4. Adjust valve knob to the desired cooking temperature.
Using the Lighting Stick to Light the Side Burner
1. Open lid while lighting the burner. Lid must remain open while burner is lit
GSS3220AN
Instruction Manual

Lighting Your Grill

Attempting to light the burner with the lid closed may cause
If the burner does not light, repeat 2 or 3 more times.
15
Push