Assembly Instructions - Tera Gear GSF2818A Manual

Ter 75k btu 4+1+1 pro gas grill
Table of Contents

Advertisement

Assembly Instructions

Remove all contents from the carton packaging. Make sure all parts are present before attempting assembly. Once the grill is
fully assembled, go back and check to make certain all the bolts are secure. Tighten again using the screwdriver provided if
necessary.
Estimated Assembly Time: 45 minutes.
Step 1
(a) Inset the caster (U) into the four holes on the opposite
side of the cart base (S).
Step 3
a) Loose the four pre‐installed bolts at the top of the two
side panels. Align the extended bolts with the holes of
the side panel support (W), then lock the bolts into the
each hole and tighten by hands until secure.
b) Align the holes on two sides of the door beam (V) with
the holes on the two side panels. Insert one bolt (AAA),
one spring washer (BBB) and one flat washer (CCC) into
each hole, tighten by hands until secure.
c)
Loosen the two pre‐installed bolts on the door beam
(V) and slide the extended bolts into the holes on the
side panel support (W), tighten by hand until secure.
d) Align the tank stopper (R) with the holes on the left
side panel and cart base, insert one bolt (DDD), one
spring washer (EEE) and one flat washer (FFF) into each
hole, tighten by hand until secure.
e) Go back and tighten all bolts by the screwdriver
provided.
Step 2
a) Loosen the four pre‐installed bolts on the cart base (S) and
allow 1/4 bolt's length to extend from the bottom panel.
b) Align the two holes on the bottom of the left side cart
panel (O) with the two bolts extended from the cart base
and push down the left side panel until it locks into place.
Tighten bolts by hands until secure.
c) Repeat the above procedure to assemble the right side
panel (Q).
d) Loosen the four pre‐installed bolts on the left side panel
and right side panel. Align the pre‐drilled holes of the back
panel (P) with the extended bolts on the two side panels,
slide the bolts into each hole and tighten by hands until
secure.
e) Go back and tighten all bolts by the screwdriver provided.
- 8 -

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents