Tera Gear TG 1201 2561 Instruction Manual page 11

Step 10 (Side knob & knob seat assembly)
a) Align the holes on the side knob seat (N) with
the holes on the right side shelf and the side
burner valve. Screw one bolt (BB) and one flat
washer (EE) into each pre-drilled hole by hand.
b) Tighten the bolts using the screwdriver
provided.
c) Insert the side knob (M) onto the valve shaft.
GSS3220AN
Instruction Manual
10
Step 11 (Side burner assembly)
a) Open the side burner lid and place the
right side burner assembly (O) onto
the right side shelf. Make certain the
venturi tube is connected properly with
valve.
b) Align the four holes on the right side
burner assembly (O) with the four
holes on the right side shelf. Insert one
bolt (BB) into each hole from above
and one flat washer (EE), one spring
washer (FF) and one nut (GG) into
each bolt from bottom. Tighten all
bolts by hand.
c) Connect the side burner ignition wire
by sliding it onto the electrode on the
right side burner assembly.
d) Go back and tighten all bolts using the
screwdriver provided.