Table of Contents
Advertisement
Remove all contents from the carton packaging. Make sure all parts are present before attempting assembly. Once the grill is
fully assembled, go back and check to make certain all the bolts are secure. Tighten again using the screwdriver provided if
necessary.
Estimated Assembly Time: 45 minutes.
Step 1
a)
Align the holes on the left two swivel casters (Y)
with the holes on the left bottom panel (U). Screw
a bolt (AAA) along with a spring washer (BBB) and
a flat washer (CCC) into each pre‐drilled hole.
Tighten by screwdriver until secure.
b)
Repeat the above procedure for the right two
rigid casters (Z) on the right bottom panel.
Step 3
a)
Align the holes on the latch magnet panel (Q) with the holes
on the front of cart bottom. Insert one bolt (DDD) along with
a spring washer (EEE) and a flat washer (FFF) into each pre‐drilled
hole.
b)
Loosen the four pre‐installed bolts on the front cart bottom and
allow 1/4 bolt's length to extend from the bottom panel.
c)
Align the holes on the bottom of the cart right panel fixer (X) with
the two bolts extended from the bottom panel and lock it into
place.Align the holes on the right side of the cart right panel fixed
with the cart right panel and screw a bolt (DDD) along with a spring
washer (EEE) and a flat washer (FFF) into each hole.
d)
Repeat the above procedure for the cart left panel fixer(T).
e) Go back and tighten all bolts using the screwdriver provided.
Assembly Instructions
Step 2
a) Loosen the nine pre‐installed bolts on cart bottom (U) and allow
a)
(W) with the three bolts extended from the bottom assembly.
b)
bolts by hand until secure.
c)
panel (R).
d)
hole. Go back and tighten all bolts using the screwdriver provided.
- 8 -
1/4 bolt's length to extend from the bottom panel.
Align the three large holes on the bottom of the cart right panel
Slide the right side cart panel until it locks into place. Tighten
Repeat the procedure for the cart left panel (P) and cart back
Align the holes on the right and left side of the back panel with
the holes on the right and left cart panel and screw a bolt (AAA)
along with a spring washer (BBB) and a flat washer (CCC) into each
Advertisement
Table of Contents
