Assembly Instructions - Tera Gear TER 25K BTU PRO Manual

Remove all contents from the carton packaging. Make sure all parts are present before attempting assembly. Once the grill is
fully assembled, go back and check to make certain all the bolts are secure. Tighten again using the screwdriver provided if
necessary.
Estimated Assembly Time: 30 minutes.
Step 1
a) Align the holes on the bottom panel (A) with the holes on the left lower frame (B)
and right lower frame (D).
b) Screw a bolt (CC) along with a lock washer (DD) and a flat washer (GG) into each
pre‐drilled hole. Tighten by screwdriver until secure.
c) Align the holes on the front lower panel (C) with the holes on the left lower frame
(B) and the right lower frame (D). Screw a bolt (AA) along with a lock washer (DD)
and a flat washer (EE) into each pre‐drilled hole. Tighten by screwdriver until
secure.
d) Align the hole on the wheel (F), and the wheel pad (AH) with the hole on left
lower frame (B), insert the wheel axle (E) into the hole. Then seal with a wheel nut
(HH).
e) Cover a wheel cap (G) on each wheel.
b) Align the holes on the cart back panel (K) with the holes on the cart frame and screw a bolt (AA)
along with a lock washer (DD) and a flat washer (EE) into each pre‐drilled hole.
c) Tighten all bolts by screwdriver until secure.
SS
Step 5
a) Align the holes on the heating plate support (X) with the holes on the grill body (Q), then
screw a bolt (FF) from the outside of grill body into each pre‐drilled hole. Seal with a
heating insulation washer (LL), a flat washer (KK) and a lock washer (JJ) onto each bolt,
then screw a wing nut (MM) onto each bolt. Tighten by hand until secure.
b) Tighten all bolts by screwdriver until secure.

Assembly Instructions

Step 2
a) Insert the feet of the right upper frame (J) into the hole on the right
lower frame.
b) Insert the feet of the left upper frame (H) into the hole on the left
lower frame.
Step 3
a) Place the front upper panel (I) on the front lower panel. Align the
holes on the front upper panel (I) with the holes on the cart frame,
screw a bolt (AA) along with a lock washer (DD) and a flat washer (EE)
into each pre‐drilled hole. Tighten by screwdriver until secure.
Step 4
a) Insert the valve shafts of the regulator & valve assembly (M) into the pre‐drilled
holes on the control panel (N), insert the bezels (AF) onto the shafts then screw a
bolt (SS) into each holes, tighten bolts by screwdriver until secure.
b) Insert the Knobs (O) on the valve shafts.
c) Insert the igniter (L) into the pre‐drilled hole in the control panel (N). Tighten by
hand until secure.
d) Align the holes on the control panel (N) with
the holes on the upper frame, and then screw a
bolt (AA), along with a lock washer (DD) and a
flat washer (EE) into each pre‐drilled hole.
Tighten by hand until secure.
e) Tighten all bolts by screwdriver until secure.
- 8 -