Tera Gear TG 1201 2561 Instruction Manual page 9

Step 5 (Basket assembly)
a) Pull out the basket support (H) and loosen
the pre-installed flat washer, spring washer
and nut on the shaft of the basket (G). Insert
the four shafts of the basket into the four
holes of the basket support.
b) Insert the flat washer, spring washer and nut
on to each shaft from bottom of the basket
support. Tighten by hand until secured.
GSS3220AN
Instruction Manual
Step 4 (Assemble the front beam to the cart)
a) Place the front beam (F) on the two cart
side panels.
b) Align the two holes on the right end of front
beam (F) with the top & side two holes on
the frame of cart right side panel.
c) Insert one bolt (AA) with one spring washer
(DD) and one flat washer (CC) into each
pre-drilled hole. Tighten bolts by hand until
secured.
d) Repeat the procedure for the frame of cart
left side panel.
e) Go back and tighten all bolts using the
screwdriver provided.
Step 6 (Basket support assembly)
a) Align the four holes on the track of the basket
support (H) with the four holes on the cart
bottom.
b) Insert one bolt (AA), one spring washer (DD)
and one flat washer (CC) into each hole.
c) Go back and tighten all bolts using the
screwdriver provided.
8