Tera Gear TG 1201 2561 Instruction Manual page 17

2. Remove the lighting stick then insert a match into the end of lighting stick. Light the match.
3. Once lit, place the flame to reach the burner ports. (See diagram to right.)
4. Press the control knob and rotate it counterclockwise to the ''HIGH''
position. The burner should light immediately.
5. Adjust burner to the desired cooking temperature.
Confirm that the burner is properly lit and that the flame pattern is as desired (see fig. A, B and C below for the proper
flame patterns). If the flame pattern is other than normal, consult the Troubleshooting on page 22 for corrective action
FIG. A
Normal: Soft blue flames with yellow
tips between I inch - 2 inches high.
Burner installation and adjustment
1. Hook should face upwards.
Lighting Infrared Burner
1. Open lid while lighting burner.
2. Make sure the control knob is locked in the OFF position.
3. Open natural gas valve
4. Push and turn control knob to HIGH setting. After lighting, please observe the ceramic plate on the surface of burner; it
should feel warm after 5-10 seconds and the color of the ceramic plate should turn red in 2-3 minutes.
5. If burner does not light on the first try, turn the control knob to its OFF position and wait 5 minutes for gas to clear
before trying again. If burner flame goes out during operation, immediately turn the gas OFF and open lid to let the gas
clear for about 5 minutes. Attempt to re-light.
6. Clean your grill after each use, DO NOT use abrasive or flammable cleansers, as it will damage the parts of this
product and may start a fire. Clean with warm soapy water.
Observing the Heat and Color of the Infrared Ceramic Burner when lit
● Flame of infrared burner might be visible in shaded area.
● After burner is lit, it should feel warm in 5-10 seconds and color of the ceramic plate turns red in approximately 2-3
minutes.
GSS3220AN
Instruction Manual
2 in.
Observe flame height when lit:
Flame should be a blue/yellow color between 1 to 2 inches high.
1 in.
0 in.
Out of adjustment: Noisy hard blue
flames – too much air.
1. Release the screw on venturi
2. Adjust the flame by turning the
3. Tighten the screw and make
FIG. B
tube.
collar on head of venturi tube from
back side of the grill and do not
take apart the venturi tube.
certain it is secured.
16
FIG.C
Poor combustion: Wavy, yellow
flames- too little air.
1. Overlap 14 mm between
venturi tube and nozzle
when assembling.
2. Keep the center line of venturi
tube and nozzle on one line.