Assembly Instructions - Tera Gear Weekend Warrior GSF3916 Owner's Manual

Assembly Instructions

Remove all contents from the carton packaging. Make sure
all parts are present before attempting assembly. Once the
grill is fully assembled, go back and check to make certain
all the bolts are secure. Tighten again using the screwdriver
provided if necessary.
Estimated Assembly Time: 30 minutes
Step 1 (Cart side panels & upper beam assembly
a) Align the holes on the left end of cart bottom panel (R) with those
on the left side panel (T), then insert one bolt (KK), one spring
washer (CC) and one flat washer(DD) into each pre-drilled holes.
Tighten bolts by hand until secure. Repeat the procedure on the
right side panel (S).
b) Align the holes on the right end of the upper rear beam (O) with
those on the right side panel (S), then insert one bolt (KK), one
spring washer (CC) and one flat washer(DD) into each pre-drilled
holes. Tighten bolts by hand until secure.
c) Repeat the procedure on the left end.
d) Repeat the procedure for the upper front beam (P).
a) Go back and tighten all the bolts using the screwdriver provided.
Step 3 (Cart back panel assembly)
a) Loosen the pre-installed bolts on the leg of the
left cart side panel and allow 1/4 bolt's length to
extend from the leg. Align the hole on the cart
panel (Q) with the extended two bolts on the
leg. Push down on the back panel until it locks
into place.
Align the middle hole on the leg of the left side
b)
panel with the hole on the cart back panel (Q),
and then insert one bolt (AA), one spring
washer (CC) and one flat washer (DD) into
each pre-drilled hole. Tighten by hand until
secure.
Repeat the procedure for the right side of cart
c)
back panel.
d) Go back and tighten all the bolts using the
screwdriver provided.
GSF3916
Owner's Manual
Step 2 (The caster assembly)
Screw one caster (Y) into each pre-drilled hole
a)
on the feet of the side panels until secure.
Go back and tighten all the bolts using the
b)
spanner provided.
7