Tera Gear TG 1201 2561 Instruction Manual page 10

Step 7 (Door assembly)
Insert the bottom pin of left door (I-1) into the
a)
pre-drilled hole on the cart bottom panel.
Push down the top pin of left door
b)
it into the pre-drilled hole on the left end of
cart front beam.
c) Repeat the procedure for the right door (I-2)
assembly.
d) Close the two doors.
Step 9 (Side shelves assembly)
a) Loosen the three pre-installed bolts on the right
side of body assembly and allow 1/4 bolt's length to
extend from body assembly.
b) Align the holes on the right side shelf (L) with the
bolts extended from the right side of body
assembly. Push down the right side shelf until it
locks into place.
c) Align the holes on right side shelf with the holes on
the control panel and body assembly.
d) Insert one bolt (AA) into each pre-drilled holes.
Tighten bolts by hand until secure.
e) Repeat the procedure for the assembly of left side
shelf (K) and body assembly.
f) Go back and tighten all bolts using the screwdriver
provided.
GSS3220AN
Instruction Manual
and insert
9
Step 8 (Assemble the body to the cart)
Put the body assembly (J) on the top of cart
a)
assembly.
a) Align the two holes on the top of cart right side panel
with the two holes on the right of body assembly.
b) Insert one bolt (AA) with one spring washer (DD) and
one flat washer (CC) into each pre-drilled hole.
c) Tighten bolts by hand until secure.
d) Repeat the procedure for the left end assembly.
e) Go back and tighten all bolts using the screwdriver
provided.
Attention:
Unpack the hose assembly (located
underneath the firebox) prior to assembling
the grill body to the cart, and pull out the hose
to the cart side panel when go ahead to this
step.