Grip Shift Installation - Dynacraft SINGLE SPEED Owner's Manual

GRIP SHIFTERS
Grip Shift - Installation
1. Slide front Grip Shift assembly over left side of handlebar leaving proper clearance for handlebar grip. If
necessary, move the brake lever to accommodate Grip Shift and handlebar grip.
2. Rotate assembly until cable exits beneath brake lever with adequate clearance for brake lever movement.
3. Firmly tighten recessed clamp screw. Installation torque should be 20 in/lbs.
4. Slide the 7/8" plastic washer over handlebar. The washer prevents the grip from interfering with Grip Shift
rotation.
5. Slide handlebar grip over handlebar. Thread the cable inner wire through cable housings and frame, and
attach to derailleur. Make sure that the cable is in the V groove at the derailleur attachment bolt. If trimming
the cable housing is necessary, be sure to replace the housing end cap.
6. Adjust indexing.
7. Slide rear Grip Shift over right side of handlebar and repeat steps 2 - 6.
8. Actuate front and rear brake levers to be certain of proper operation. If Grip Shift interferes with brake lever
movement, rotate brake lever or Grip Shift. Check for proper brake operation again.
|
85
DETAILED MAINTENANCE