Accessories; Reflectors - Dynacraft SINGLE SPEED Owner's Manual

ACCESSORIES

Your bike may come with some or all of these accessories
that require attachment and/or assembly.
Kickstand
If the kickstand is not mounted to your bicycle, place
the bicycle in an upright position against a wall or have
someone hold it upright. Place the kickstand in the bracket
mounted on the frame and use the fixing bolt secure
the kickstand in place. Be sure to tighten the fixing bolt
securely. Some kickstands use a top plate to locate the
bolt and secure the kickstand using a fixing bolt. Be sure
to tighten the axle nut. The guard will sit between the frame
and the axle nut.
Rear Derailleur Guard
Other: Some 20", 24" and 26" model bicycles come with
a rear derailleur guard to protect the rear derailleur from
damage. To install, remove the rear wheel axle nut on the
drive side, install the rear derailleur guard over the axle
with the U-shaped guard pointing down, and retighten the
axle nut. The guard will sit between the frame and the axle
nut.

Reflectors

Attach the white reflector to the front reflector bracket
and secure to the fork or handlebar using the hardware
provided. Attach the red reflector to the rear reflector
bracket and secure to the frame or seatpost, depending on
the bracket style, with the hardware provided.
WARNING
Tighten both rear wheel axle nuts. Failure to do this
may cause the rear wheel to dislodge from the frame
dropouts resulting in serious damage or injury.
WARNING
The kickstand is designed to support the BICYCLE
ONLY; not the bicycle and the rider.
|
46
ASSEMBLY