Safety Checklist; Brakes; Wheels & Tires; Steering - Dynacraft SINGLE SPEED Owner's Manual

SAFETY CHECKLIST

Before every ride, it is important to carry out the following safety checks: (For information and instructions on
performing specific equipment checks, locate the relevant section in the manual using the index on page vii).

1. Brakes

• Ensure front and rear brakes work properly.
• Ensure brake shoe pads are not over worn and are correctly positioned in relation to the rims.
• Ensure brake control cables are lubricated, correctly adjusted, and display no obvious wear.
• Ensure brake control levers are lubricated and tightly secured to the handlebar.

2. Steering

• Ensure handlebar and stem are correctly adjusted and tightened, and allow proper steering.
• Ensure that the handlebars are set correctly in relation to the forks and the direction of travel.
• Check that the head set locking mechanism is properly adjusted and tightened.
• If the bicycle is fitted with handlebar end extensions, ensure they are properly positioned
and tightened.
3. Cranks and Pedals
• Ensure pedals are securely tightened to the cranks.
• Ensure cranks are securely tightened to the axle and are not bent.
4. Wheels and Tires
• Ensure tires are inflated to within the maximum recommended limit as displayed on the
tire sidewall.
• Ensure tires have tread and have no bulges or excessive wear.
• Ensure rims run true and have no obvious wobbles or kinks.
• Ensure all wheel spokes are tight and not broken.
• Check that axle nuts are tight.
|
16
BEFORE YOU RIDE