Seat And Seatpost - Dynacraft SINGLE SPEED Owner's Manual

Seat
Clamp
Adjusting Nut
|
31
ASSEMBLY

SEAT AND SEATPOST

Attach the seat to the seatpost by loosening the nuts on the seat
clamp. Insert the tapered end of the seatpost into the seat clamp
until it is at the top of the clamp. Partially tighten the nuts on the
seat clamp turning each side evenly until the seat is snug, but
can still be turned. Insert the seat assembly into the frame of the
Seatpost
bicycle and adjust the seat to the proper height. The seatpost must
be inserted to at least the "Minimum Insertion" line marked on the
Quick
seatpost. If equipped with a quick release, tighten the adjusting nut
Release
by hand and move the quick release lever to the closed position.
You should feel considerable resistance while moving the lever.
If not, reopen and retighten the lever, then move it to the closed
position so it is in line with the frame as pictured. Ensure the lip on
the binder clamp is fitted completely against the top of the seat
tube of the frame. With the seatpost inserted, tighten the binder
bolt securely. Position the top of the seat parallel with the ground.
Push the front of the seat up and down to firmly mesh the serrations
together. The serrations must mesh completely together to ensure
a stabilized riding position. Securely tighten the nut on the seat
clamp. If there is a nut on both sides of the clamp, tighten each one
by alternating from one to the other. Check for tightness by twisting
the seat from side to side, and from front to back. If the seat moves
at the seat clamp or quick release, reposition and retighten the
appropriate clamping mechanism.
NOTE: Comfort style bicycles may be equipped with a
suspension seatpost (see diagram - upper left).