Final Check - Dynacraft SINGLE SPEED Owner's Manual

FINAL CHECK

• Check that the brakes operate smoothly with no binding. To test, apply the brakes while trying to push
the bicycle forward to make sure they will stop the bicycle. Do not ride your bicycle unless the brakes are
functioning properly.
• Test the security of the handlebar within the stem, and the stem within the fork steerer tube, by clamping the
front wheel between your knees and trying to move the handlebar up and down, and from side to side. The stem
and/or handlebar should not move when applying pressure.
• After all adjustments have been made, shift through every gear several times at varying speeds. This will
ensure all your adjustments are correct and will allow you to pinpoint any trouble areas. If you encounter any
problems, refer top the appropriate section and make any necessary adjustments.
• Check the tire pressure and inflate each tire to the recommended PSI as stated on the sidewall of the tire.
• Check that the kickstand operates smoothly and the kickstand bolt is secured tightly.
• Finally, examine the bicycle. Make sure all accessories are attached and all quick releases, nuts and bolts
have been tightened securely.
• Correct maintenance of your bicycle will ensure many years of happy riding. Service your bicycle regularly by
referring to the relevant sections of this manual, or take it to a professional bicycle shop.
Remember: Always wear a helmet and obey all traffic laws.
WARNING
Never inflate a tire beyond the maximum pressure marked on
the tire's sidewall. Exceeding the recommended pressure may
blow the tire off the rim, which could cause damage to the
bicycle and injury to the rider and bystanders.
|
51
ASSEMBLY