Dynacraft SINGLE SPEED Owner's Manual page 28

SEAT AND HANDLEBAR MOUNTING REFLECTORS
Slide reflector over bracket (shown on page 19) and ensure that the tab clicks into the top hole of the bracket.
Next, remove the clamp screw and open the clamping reflector bracket. Place clamping reflector bracket
around the handlebar or seatpost. If the clamp is too loose, insert the shim inside of the clamp. Tighten the
clamp screw to hold reflector assembly in place. Finally, adjust the reflector such that it is upright and facing
away from the bike.
SEATPOST MOUNT REFLECTOR BRACKET ASSEMBLY
Slide reflector over bracket as shown in diagram below and ensure that the tab clicks into the top hole of the
bracket. Insert one washer onto the hex bolt and insert hex bolt through the reflector bracket and around the
seatpost. Tighten bolts until snug, making sure the reflector is in an upright position. See diagram below.
PEDAL REFLECTORS
Pedal reflectors are required by federal law. Maintain them and replace any that are missing.
|
20
BEFORE YOU RIDE