Rear Wheel Installation - Dynacraft BALANCE CYCLE Owner's Manual

REAR WHEEL INSTALLATION

STEP 1. Loosen axle nuts on rear wheel axle with fingers so that nuts are still
attached to axle.
STEP 2. Guide rear wheel into rear fork slots, position axle in rear fork slots,
make sure washers and nuts are positioned outside of rear fork legs
(see Figure 10).
SAFETY
LOCKING HOLE
FIGURE 10
NOTE: Safety tabs should be
locked into safety locking holes
(see Figure 10).
STEP 3. Tighten wheel nuts on left and right side of rear wheel axle securely.
NOTE: When tightening, be sure the rear wheel is centered in the frame.
8
FIGURE 11
AXLE NUT SAFETY LOCKTAB
WASHER