Pedals And Crank Set - Dynacraft SINGLE SPEED Owner's Manual

|
55
ASSEMBLY

PEDALS AND CRANK SET

Check for the right (R, red) sticker and left (L, green) sticker on each
pedal and crank arm. Match the appropriate pedal to each crank
(right to right and left to left) for assembly. Start each pedal spindle
by hand to avoid stripping the threads. Tighten with a 15 mm narrow
open ended wrench so that the shoulder of the pedal spindle is
securely tightened against the crank arm. Note that the right hand
pedal attaches to the chainwheel side crank arm with a right-hand
(clockwise) thread. The left pedal attaches to the other crank arm
and has a left-hand (counterclockwise) thread. It is very important
that you check the crank set for correct adjustment and tightness
before riding your bicycle.
WARNING
Attachment of an incorrect pedal into a crank arm will cause irreparable
damage. Unless the shoulder of the pedal spindle is tight to the face of
the crank arm, the pedal may back out causing serious injury or death.
Make it tight so the shoulder is in complete contact with the surface
of the crank arm. Before your first ride, please check to ensure your
pedals are attached correctly.
New boltless cranks may become loose with initial use, refer to page
100 for crank type identification and instructions for adjustment and
maintenance. Tightening may have to be repeated during initial use.
WARNING
Never ride your bike if the cranks are loose. This
could damage the crank arms beyond repair, and
result in a loss of control, injury or death.