Cantilever - Dynacraft SINGLE SPEED Owner's Manual

CANTILEVER BRAKES
|
57
ASSEMBLY

CANTILEVER

If fitted with cantilever type brakes, insert the brake cable
into the link wire lead, and notch the cable end into the slot
of the left brake arm. Loosen the anchor bolt on the right
brake arm and thread brake cable through it. Adjust the
brake shoes using a 10 mm wrench and 5 mm Allen key so
that they are parallel with the rim and are positioned 1-2 mm
away from the rim. Several adjustments may be necessary to
achieve the correct brake position.
WARNING
When assembling or adjusting the brakes, make sure the cable
anchor is tight. Failure to securely tighten the nut could result in
brake failure and personal injury.