PLEASE NOTE: Not all axles are able to accept axle pegs. Please consult your local bicycle specialist if
you have any questions. Some BMX bicycles come with two or four pegs.
NON-THREADED
Make sure the axle nuts are tight with a 15 mm wrench
or adjustable wrench. Place the domed washer (if sup-
plied) over the axle and axle nut. Slide the peg onto
the axle, and then using the supplied tool or a 15 mm
socket and extended driver, thread the peg-fixing nut
onto the axle. Tighten the nut clockwise until snug.
Repeat for all the remaining pegs.
|
63
ASSEMBLY
THREADED
This style of peg is threaded to fit the axle. Make sure
axle nuts are tight using a 15 mm wrench or adjustable
wrench. Place the domed washer (if supplied) over the
axle and axle nut, and then thread the peg on the axle
turning clockwise until snug.