Helmets - Dynacraft SINGLE SPEED Owner's Manual

HELMETS

Local laws of most places require a helmet, and common sense
requires them in other places where it is not the law. It is strongly
advised that a properly fitting, CSPC approved, bicycle safety
helmet be worn at all times when riding your bicycle. In addition, if
you are carrying a passenger in a child safety seat, they must also
be wearing a properly fitted helmet.
The correct helmet should:
• be comfortable
• be lightweight
• have good ventilation
• fit correctly
WARNING
Always wear a properly fitted helmet when riding a bicycle. Falling off your bicycle without a helmet can cause
serious injury or death. Many states require specific safety devices. It is your responsibility to familiarize yourself
with the laws of the state where you ride and comply with all applicable laws, including properly equipping your-
self and your bike as the law requires. Reflectors are important safety devices which are designed as an integral
part of your bicycle. Federal regulations require most types of bicycles to be equipped with front, rear, wheel,
and pedal reflectors. These reflectors are designed to pick up and reflect street lights and car lights in a way
that helps you to be seen and recognized as a moving bicyclist. Check reflectors and their mounting brackets
regularly to make sure they are clean, straight, unbroken, and securely mounted. Replace damaged reflectors
and straighten or tighten any that are bent or loose.
REFLECTORS
Your bicycle is supplied with one front (white), one rear (red), two wheel (white), and two pedal (orange) reflec-
tors. These are an important safety and legal requirement, and should remain securely fitted and in good, clean
conditions at all times. Periodically, inspect all reflectors, brackets, and mounting hardware for signs of wear or
damage. Replace immediately if damage is found. Some bicycles will require you to install your reflectors onto
your bicycle.
|
18
BEFORE YOU RIDE