Pre-Ride Checklist - Dynacraft 8802-33 Owner's Manual

Edirt bike 24v/36v electric vehicles
Table of Contents

Advertisement

PRE-RIDE CHECKLIST

Loose Parts
There should not be any unusual rattles or sounds from loose parts or broken com-
ponents. If you are not sure, ask an experienced mechanic to check or call customer
service
Brake
Check the brake for proper function. When you squeeze the lever, the brake should
provide positive braking action. When you apply the brake with the speed control on,
the brake cut-off switch will stop the motor.
Tire Inflation
Periodically inspect the tires for excess wear and replace as needed. Regularly check
the tire pressure and inflate as needed.
Safety Gear
Always wear proper protective equipment such as an approved safety helmet. Elbow
pads, kneepads, pants and long sleeves are recommended- Always wear shoes,
never ride barefooted or in sandals, and keep shoelaces tied and out of the way of
the wheels, motor and drive system.
Frame, Fork and Handlebars
Check for cracks or broken connections. Although broken frames are rare, it is pos-
sible for an aggressive rider to run into a curb or wall and wreck, bend or break the
frame. Get in the habit of inspecting your product regularly.
WARNING:
inflated the tires to the correct PSI and charged the battery for at least
18 hours.
Failure to follow these instructions may also damage your product and void
your warranty.
WARNING
• Turn off power switch when not in use.
• Batteries may become damaged and could no longer accept a charge, if switch is
left in the ON position when not in use.
• Fully charge the battery before storage.
Note: Failure to recharge the battery at least once a month may result in a battery
that will no longer accept a charge.
Do not use this product for the first time until you have
15

Advertisement

Table of Contents
loading

Table of Contents