Dmx Mode; Master/Slave Mode; Standalone (Program) Mode; Manual Color Adjustment - Blizzard Lighting ToughPar V12 Manual

DMX Mode

Allows the unit to be controlled by any universal DMX controller.
1.) The default mode for the fixture is DMX, which appears as
select a different DMX address, using the <MENU> button, select
Use the <UP/DOWN> buttons to select the correct address, then hit <ENTER> to confirm.
Setting the DMX Channel Mode:
1.) To select a DMX channel mode, press the <MENU> button, then use the <UP> or
<DOWN> buttons until the display reads
the <UP> or <DOWN> buttons until the display reaches your desired channel mode. Press
the <MENU> button to confirm.
Stand-Alone, Master/Slave, Sound Active Modes:
Allows a single or Master/Slaved units to run factory installed programs at user selectable speeds.
1.) To set the fixture in Flash/Fade mode, select
<ENTER> button.
2.) Now, you can adjust the flash settings from
FA00-FA15.
3.) To use the fixture in automatic mode, select
use the <UP/DOWN> to choose from
confirm.
4.) Adjust the speed of the chase as above using
press the <ENTER> button to confirm.
5.) To set the fixture as a slave unit, select
SL.AU
flashing

Standalone (Program) Mode:

Allows a single unit to display a variety of colors and programs without a DMX controller.
1.) To set the fixture in manual mode, select
To confirm, press the <ENTER> button.
2.) Now, select the program by using the <UP> and <DOWN> buttons to select
Pr35
. To confirm, press the <ENTER> button.

Manual Color Adjustment:

Allows the user to adjust the color balance of the fixture. These settings are global, they will effect all
modes.
1.) Use the <MENU> and <UP/DOWN> button to select
bL--
Level),
<ENTER> button to confirm your choice.
2.) Using the <UP/DOWN> buttons, select the maximum level for each color between
x255
(000=off), then hit <ENTER> to confirm.
ToughPar V12 Manual Rev. B
Then press the <ENTER> button to confirm.
to indicate it is in slave mode.
AL--
(Blue Level), (Amber Level) or
Page 12
Chnd
and press the <MENU> button. Then use
FLAS or FAdE
FL00-FL15
ASC-
, and press the <ENTER> button. Then
AS00-AS15
, then press the <ENTER> button to
SP15
(slowest) to
SLAU
, and hit <ENTER>. The unit will display a
Pr--
.
rL--
UL--
(White Level), then press the
d001
on the LED Readout. To
Addr
,then hit <ENTER>.
. To confirm, press the
or the fade settings from
SP00
(fastest) then
Pr00-
GL--
(Red Level),
© 2013 Blizzard Lighting, LLC
(Green
x000-