Quick Installation Reference - Crestron CHV-TSTAT Operation And Installation Manual

Thermostats

Quick Installation Reference

1. Select a suitable location and run the connecting wires from the heating/cooling system and the Cresnet system.
Refer to page 5 for a description of the thermostat connectors.
Refer to page 7 for Network wiring details.
Use the appropriate wiring diagram:
•
Heating or Cooling System Powered (Refer to page 8).
•
Separately Powered (Refer to page 9).
•
Two Wire Heat Only (Refer to page 9).
•
Three Wire Heat Only with Fan (Refer to page10).
•
Single Stage Heat/Cool (Refer to page 10).
•
Single Stage Heat Pump (Refer to page 11).
•
Two Stage Heat Pump (Refer to page 11).
2. Separate the thermostat from the backplate to expose the connections and mounting holes.
3. Mount the thermostat backplate directly to the wall with wall anchors (not provided) and screws (not provided)
or to a single-gang box (not provided) mounted horizontally, and connect the wiring. Refer to page 12 for
detailed mounting instructions and page 5 for detailed connector information.
4. Install the thermostat on the backplate and setup the thermostat (Refer to page 14).
5. Configure the thermostat (Refer to Operating the Thermostat on page 18).
ii • Contents
Crestron CHV-TSTAT and CHV-THSTAT
Operations and Installation Guide – DOC. 8163