Installation - Crestron CHV-TSTAT Operation And Installation Manual

Thermostats
12 • Thermostats: CHV-TSTAT and CHV-THSTAT
Crestron CHV-TSTAT and CHV-THSTAT

Installation

The location of the thermostat can affect its performance and efficiency. Install the
thermostat away from direct sunlight, drafts, doorways, skylights, and windows. Also
make sure the thermostat is conveniently located for programming, and do not mount
on an exterior wall. The thermostats may be mounted directly to drywall or to a
single-gang box. Refer to the following illustrations. Do the following to install the
CHV-TSTAT or the CHV-THSTAT.
NOTE: When installing directly on drywall, use anchoring screws and hardware.
Make sure the back of the thermostat is flush with drywall and the unit is level.
Required Hardware
•
Thermostat
•
Phillips screwdriver (not supplied)
•
Two 6/32 x 1 inch panhead screws (supplied) for mounting to a
single-gang box
•
Single-gang box (not supplied)
•
Wall anchors (not supplied) and screws (not supplied) for
mounting directly to drywall
1. Separate thermostat front plate from back plate (you may need to exert force
when removing the faceplate).
2. Turn of the circuit breaker when connecting power to the thermostat, and
connect wiring as required (wiring goes through center hole on back plate).
3. Attach back plate to drywall with screws and anchors (anchor hardware not
provided). Thermostat may also be mounted to a single-gang box mounted
horizontally, using the two 6/32 x 1 in panhead screws provided. Ensure that
the thermostat is level and the ventilation holes in the backplate are not
blocked.
4. Note orientation of front plate connection leads and reattach the front plate
on the back plate (make sure front plate snaps in place and no wires are
pinched).
NOTE: If replacing an existing thermostat, make note of the wire colors and positions
before removing the old thermostat.
Operations and Installation Guide – DOC. 8163