Operating The Thermostat - Crestron CHV-TSTAT Operation And Installation Manual

Thermostats
Main Screen
76
o F
o 74
F
MODE
HEATING
HEAT ONLY
%
43
NET DEFAULT
VIEW
H1 H2 AX
System Mode
System Mode
MODE
HEAT COOL AUTO OFF
VIEW
AUX HEAT ONLY
NOTE: The AUX HEAT ONLY is for the
backup heating system on Heat Pump systems
only. Allows the backup system to operate
without operating the heat pump.
Fan Mode
Fan Mode
MODE
AUTO ON
VIEW
Crestron System
Crestron Sys
MODE
ONLINE HOLD
VIEW
18 • Thermostats: CHV-TSTAT and CHV-THSTAT
Crestron CHV-TSTAT and CHV-THSTAT

Operating the Thermostat

After setup, configure the thermostat using the following screens.
The Main Screen displays the Current Temperature, System Mode, Fan
Mode, and Set Point temperatures. The CHV-THSTAT also displays
Relative Humidity and Humidifier Mode. Press the up ▲arrow button to
increase the set point temperature. Press the down ▼arrow button to
decrease the set point temperature.
This screen also indicates the system currently running:
H1 – Heat System or Stage 1 Heat System
H2 – Stage 2 Heat System
AX – Auxiliary Heating System
C1 – Cooling System or Stage 1 Cooling System
C2 – Stage 2 Cooling System
It may also be necessary to access a series of screens. Pressing MODE
button allows the user to access System Mode, Fan Mode, Crestron System
On/Offline, and Global Update mode. The "System Mode" screen appears
when the MODE button is initially pressed once. Use the up ▲and down
▼arrow buttons to select HEAT, COOL, AUTO, OFF or AUX Heat Only.
NOTE: The AUTO selection allows the system to switch between Heat and
Cool automatically as needed to maintain the temperature.
Pressing the MODE button again displays the "Fan Mode" screen.
Use the up ▲and down▼arrow buttons to select AUTO or ON.
NOTE: In AUTO, the fan runs only when the system calls for heat or cool.
In ON, the fan runs continuously.
Pressing the MODE button again displays the Crestron System screen.
Use the up ▲and down▼arrow buttons to select ONLINE or HOLD
(offline).
Operations and Installation Guide – DOC. 8163